NISSAN 2013 Quest - Owner's Manual - Manual (Page 119)

Black plate (115,1)
[ Edit: 2013/ 3/ 26 Model: E52-D ]
SIC3585
Instrument brightness control
The instrument brightness control operates
when the ignition switch is in the ON position.
To adjust the brightness of instrument panel
lights, push the control switches. Pushing the
upper switch
*
A will brighten the lights. When
the brightness reaches the maximum level, a
beep will sound. The lower switch
*
B dims the
lights. Repeatedly pushing the lower switch will
turn the lights off and a beep will sound.
SIC3671
TURN SIGNAL SWITCH
* 1 Turn signal
Move the lever up or down to signal the turning
direction. When the turn is completed, the turn
signals cancel automatically.
* 2 Lane change signal
To indicate a lane change, move the lever up or
down to the point where lights begin flashing.
If the lever is moved back right after moving up
or down, the light will flash 3 times.
To cancel the flashing, move the lever to the
opposite direction.
SIC3672
FOG LIGHT SWITCH (if so equipped)
To turn the fog lights on, turn the headlight
switch to the
position, then turn the switch
to the position. To turn them off, turn the
switch to the OFF position.
The headlights must be on for the fog lights to
operate.
When the headlight switch is in the AUTO
position (if so equipped):
. Turning the fog light switch to the
position will turn on the headlights, fog lights
and the other lights while the ignition switch
is in the ON position or the engine is
running.
Instruments and controls 2-37
Condition: