NISSAN 2012 Quest - Owner's Manual - Manual (Page 244)

Black plate (241,1)
[ Edit: 2011/ 10/ 27 Model: E52-D ]
FM·AM radio operation
The audio system operates when the ignition
switch is in the “ACC” or “ON” position.
FM·AM button:
When the FM·AM button is pushed while the
audio system is off, the audio system will turn on
and the radio will turn on.
If another audio source is playing when the
FM·AM button is pushed, the audio source will
automatically turn off and the radio will turn on.
To change the radio bands, push the FM·AM
button to select the band.
AM ? FM1 ? FM2
TUNE button:
When adjusting the broadcasting station fre-
quency manually, push the TUNE button
or
until the desired frequency is achieved.
SEEK button:
When adjusting the broadcasting station fre-
quency automatically, push the SEEK button
or for less than 1.5 seconds. When the
system detects a broadcasting station, it will
stop at the station.
SCAN searching:
Push the SCAN tuning button to tune from low
to high frequencies and stop at each broad-
casting station for 5 seconds. Pushing the
button again during this 5-second period will
stop SCAN tuning and the radio will remain
tuned to that station.
If the SCAN tuning button is not pushed within 5
seconds, SCAN tuning moves to the next
station.
Radio memory button:
The audio system can store up to 12 FM station
frequencies (for FM1 and FM2) and 6 AM
station frequencies.
To store the station frequency:
1. Tune to the desired broadcasting station
frequency by using the TUNE button or
SEEK button.
2. Push and hold a memory button (1 - 6) until
a beep sounds.
3. The channel indicator will display indicating
that the memory is stored properly.
4. Perform steps 1 - 3 for all other memory
buttons.
If the battery cable is disconnected, or if the
audio fuse blows, the radio memory will be
erased. In such a case, reset the desired
stations.
CD changer operation
The audio system operates when the ignition
switch is in the “ACC” or “ON” position.
CAUTION
. Do not force the compact disc into
the slot. This could damage the
player.
. Do not use 8 cm (3.1 in) discs.
LOAD button:
To load a CD in the CD changer:
1. Push the button for less than 1.5
seconds.
2. Select the loading slot by pushing the CD
select buttons to . If no slot is
selected, the CD changer will automatically
select a slot which is available.
3. Insert a CD into the slot with the label side
facing up. The CD will be guided automa-
tically into the slot and will start playing.
To load 6 CDs in the CD changer in succession,
push the
button for more than 1.5 seconds.
If another audio source is already playing, it will
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-61