NISSAN 2012 Quest - Owner's Manual - Manual (Page 154)

Black plate (151,1)
[ Edit: 2011/ 10/ 27 Model: E52-D ]
The power sliding door system can be operated
when all of following conditions are satisfied.
. The vehicle is stopped.
. Battery voltage is normal.
. The sliding door is unlocked.
. The fuel-filler door is closed (for driver’s side
only).
When the ignition switch is in the “ON” position,
the system can be operated in the above and
one of the following conditions.
. Selector lever is set in the “P” (Park)
position.
. Brake pedal is depressed.
. Parking brake is applied.
If the conditions are interrupted when the power
sliding door is being operated, the operation
could be stopped. In this case, meet the
conditions above and the power sliding door
operation will return to normal.
You can also switch the power lift gate between
power and manual operation using the power
door main switch. (See “Lift gate” (P.3-26).)
SPA2846
Instrument panel
*
A Driver’s side sliding door switch
*
B Passenger’s side sliding door switch
SPA2857
Door pillar
OPERATING SLIDING DOOR SWITCH
To operate the sliding doors with the sliding
door switches, turn on the power door main
switch.
. When the sliding door is fully closed, push
and hold the sliding door switch for about 1
second. The sliding door will automatically
open to the fully opened position.
. When the sliding door is fully opened, push
and hold the sliding door switch for about 1
second. The sliding door will automatically
close to the fully closed position.
. If the sliding door switch is pushed while the
sliding door is being operated automatically,
Pre-driving checks and adjustments 3-11