Controls and features – FORD 2000 Windstar User Manual
Page 96
remaining two buttons may now be programmed if this has not
previously been done.
Erasing HomeLink
ா
buttons
Individual buttons cannot be erased,
however, to erase the three
programmed buttons:
1. Hold down the two outside
buttons until the red light begins to
flash after 20 seconds.
2. Release both buttons.
Reprogramming a single HomeLink
ா
button
To program a device to HomeLink
using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
button. Do NOT release until
step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds),
position the hand-held transmitter 5–14 cm (2 to 5 inches) away from
the HomeLink
surface.
3. Press and hold the hand-held transmitter button.
4. The HomeLink
indicator light will flash, first slowly and then rapidly.
When the indicator light begins to flash rapidly, release both buttons.
The previous device has now been erased and the new device can be
activated by pushing the HomeLink
button that has just been
programmed.
Operating TravelNote
ா
TravelNote
records and stores messages for up to three minutes in total
length with simple controls. When you get an idea or remember
something important while you’re driving, you don’t have to try to
scribble it down or pull off the side of the road. All you have to do is
push a button and begin speaking.
REC
DEL
PLAY
Controls and features
96