beautypg.com

Instrumentation – FORD 2000 Windstar User Manual

Page 18

background image

The sequence of the system check report is as follows:

1. oil life in XX%

2. charging system

3. washer fluid level

4. brake fluid level

5. doors closed (driver and passenger side). This message can only be
reset by closing the door(s). If the RESET control is pressed, PLEASE
CLOSE DOOR will be displayed.

6. rear liftgate status

7. exterior lamps (headlamps, front turn, brake, tail and cornering/side
repeater lamp status)

8. traction control (if equipped)

9. fuel level

10. distance to empty

Single/Dual Display Mode

1. Select this function from the
SETUP menu for the current display
mode.

2. Press the RESET control to
change from the Single to the Dual display.

System warnings

System warnings alert you to possible problems or malfunctions in your
vehicle’s operating systems.

In the event of a multiple warning situation, the message center will
cycle the display to show all warnings by displaying each one for 4
seconds.

The message center will display the last selected feature if there are no
more warning messages. This allows you to use the full functionality of
the message center after you acknowledge the warning by pressing the
RESET control and clearing the warning message.

Warning messages that have been reset are divided into two categories:
• They will reappear on the display ten minutes from the reset.
• They will not reappear until an ignition OFF-ON cycle has been

completed.

>

Instrumentation

18