FORD 2000 Windstar - Manual (Page 127)

To install the seat:
1. Remove (if necessary) tub covers from the floor to expose the seat
mounts.
• To remove the tub cover(s), use a
screwdriver to pry the tub cover
(where indicated) upward and
out of the floor tub.
• To install the tub cover(s), first
insert the tabs located on the
opposite side of the pry location
into the slots of the floor tub then
press down on the other side of
the cover until it snaps into place
securely. (Additional tub covers
can be purchased as an accessory
from your dealer.)
2. Position the seat in the vehicle.
The second row bench seat may be indexed to be positioned to either
the far left or right hand side of the vehicle. (4-door vehicles only).
The left side of the figure is the front of the vehicle.
• Indexed to far left
Seating and safety restraints
127