Maintenance and specifications – FORD 2002 Focus v.1 User Manual
Page 262
Maintenance and Specifications
262
•
If the oil level is between the
MIN and MAX marks (2.0 SPI
engine) or between ADD and
FULL (2.0 ZetecĆengine), the oil
level is acceptable. DO NOT ADD
OIL.
•
If the oil level is below the
MIN/ADD mark, add enough oil to
raise the level within the
MIN-MAX/ADD-FULL range.
•
Oil levels above the MAX/FULL
mark may cause engine damage.
Some oil must be removed from the
engine by a service technician.
7. Put the indicator back in and
ensure it is fully seated.
Adding engine oil
1. Check the engine oil. For
instructions, refer to Checking the
engine oil in this chapter.
2. If the engine oil level is not
within the MIN and MAX/ADD and
FULL ranges, add only certified
engine oil of the recommended
viscosity. Remove the engine oil
filler cap and use a funnel to pour
the engine oil into the opening.
3. Recheck the oil level. Make
sure the oil level is not above
the MAX mark (2.0 SPI engine)
or the FULL mark (2.0 ZetecĆ
engine) on the dipstick.
4. Replace oil filler cap and ensure
it is fully tightened.
2.0 SPI engine
2.0 ZetecĆengine