FORD 2011 Edge v.1 - Manual (Page 141)

Erasing personal code
1. Enter the factory set 5–digit code.
2. Within five seconds, press the 1
• 2 on the keypad and release.
3. Press and hold the 1
• 2 for two seconds. This must be done within
five seconds of completing Step 2.
All personal codes are now erased and only the factory set 5–digit code
will work.
Anti-scan feature
If the wrong code has been entered seven times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the
control on the remote entry transmitter portion of
your integrated keyhead transmitter.
• the ignition is turned on.
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate. Note: If the two-stage unlocking
feature is disabled, all doors will unlock; for more information regarding
two-stage unlocking, refer to the Unlocking the doors/Two stage unlock
section earlier in this chapter.
To unlock all doors, enter the factory set code or your personal code,
then press the 3
• 4 control within five seconds.
To lock all doors, press and hold the 7
• 8 and the 9 • 0 at the same
time (with the driver’s door closed). You do not need to enter the
keypad code first.
SECURILOCK
ா PASSIVE ANTI-THEFT SYSTEM
SecuriLock
௡ passive anti-theft system is an engine immobilization
system. This system is designed to help prevent the engine from being
started unless a coded integrated keyhead transmitter (IKT) or
intelligent access keys programmed to your vehicle is used. The
use of the wrong type of coded key may lead to a “no-start” condition.
The message center will display: STARTING SYSTEM FAULT.
Locks and Security
141
2011 Edge (edg)
Owners Guide, 1st Printing
USA (fus)