FORD 2012 F-150 Raptor v.3 - Manual (Page 123)

Programing the transmitters
To program HomeLink
௡ to the Genie IC2 transmitter you must first put
the Genie IC2 transmitter into Intellicode 1 mode (IC1). To do this
A. Red LED
B. Green LED
1. Press and hold one of the Genie IC2 buttons on the transmitter for
10 seconds (the LED light will change from green to green and red).
2. Press the same button twice to confirm the change to Intellicode 1
mode. If done properly the LED light will appear red.
After confirming that you have switched your Genie IC2 into IC1
mode, to continue programming
3. Hold both hand-held transmitters within 1–3 inches (2–8 centimeters)
of one another.
4. Press and hold the both the programmed Genie button and the
HomeLink
௡ button you want to program at the same time.
5. The HomeLink
௡ LED will flash rapidly when the programming is
successful.
Note: the Genie transmitter will transmit for 30 seconds. If HomeLink
௡
does not program within 30 seconds the Genie transmitter will need to
be pressed again, and Steps 3–5 repeated.
Note: If the Genie transmitter LED displays green and red release the
button. Wait 3 seconds until the LED turns off before pressing the button.
Once HomeLink
௡ has been programmed successfully, the Genie IC2
transmitter will still be in IC1 mode and must be changed back. To
return back to IC2 mode
1. Press and hold the previously programmed Genie button for
10 seconds. The LED will change from red to red and green.
2. Press the same button twice to confirm the change back to IC2 mode.
If done correctly the LED will turn green.
B A
Driver Controls
123
2012 F-150 (f12)
Owners Guide, 3rd Printing
USA (fus)