Erasing the function button codes, Reprogramming a single button, Driver controls – FORD 2012 F-150 Raptor v.3 User Manual
Page 120
2. Return to your car.
3. Press and hold the function
button you want to program for
2 seconds, then release. Repeat this
step. Depending on the brand of
garage door opener you may need
to repeat this sequence a third time.
To program additional buttons
repeat steps one through four.
For questions or comments, please contact HomeLink
at
www.homelink.com or 1-800-355-3515.
Erasing the Function Button Codes
Note: You cannot erase individual
buttons.
1. Press and hold the outer two
function buttons simultaneously for
approximately 20 seconds until the
indicator lights above the buttons
flash rapidly.
2. When the indicator lights flash,
release the buttons. The codes for
all buttons are erased.
Reprogramming a single button
To program a device to a previously trained button, follow these steps:
1. Press and hold the desired button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the button, follow Step 1 in the Programming section.
For questions or comments, contact HomeLink
at www.homelink.com or
1-800-355-3515.
Programming HomeLink
ா to a Genie Intellicodeா 2 garage door
opener
Note: The Genie Intellicode
2 transmitter must already be programmed
to operate with the garage door opener.
Driver Controls
120
2012 F-150 (f12)
Owners Guide, 3rd Printing
USA (fus)