beautypg.com

Programing the transmitters, Driver controls – FORD 2012 F-150 Raptor v.3 User Manual

Page 121

background image

Programing the transmitters

To program HomeLink

௡ to the transmitter you must first put the

transmitter into programming mode. To do this

A. Red LED

B. Green LED

1. Press and hold one of the buttons on the hand-held transmitter for
10 seconds. The LED light will change from green to green and red.

2. Press the same button twice to confirm the change to Programming
mode. If done properly the LED light will appear red.

3. Hold the transmitter within 1–3 inches (2–8 centimeters) of the
button on the sun visor you want to program.

4. Press and hold both the programmed Genie button on the hand-held
transmitter and the button on the sun visor you want to program. The
indicator light on the sun visor will flash rapidly when the programming
is successful.

Note: the Genie transmitter will transmit for up to 30 seconds. If
HomeLink

௡ does not program within 30 seconds the Genie transmitter

will need to be pressed again. If the Genie transmitter LED displays
green and red, release the button until the LED turns off before pressing
the button again.

Once HomeLink

௡ has been programmed successfully, the Genie

transmitter must be changed out of program mode. To do this:

1. Press and hold the previously programmed Genie button on the
hand-held transmitter for 10 seconds. The indicator light will change
from red to red and green.

2. Press the same button twice to confirm the change. If done correctly
the LED will turn green.

B

A

Driver Controls

121

2012 F-150 (f12)
Owners Guide, 3rd Printing
USA
(fus)