beautypg.com

Performing the tpms reset procedure, Tires, wheels and loading – FORD 2012 F-150 Raptor v.1 User Manual

Page 253

background image

Performing the TPMS reset procedure

It is recommended that you read the entire procedure before attempting.

1. Drive the vehicle above 20 mph (32 km/h) for at least two minutes
and then park in a safe location where you can easily get to all four tires
and have access to an air pump.

2. Place the ignition in the off position and keep the key in the ignition.

3. Cycle the ignition to the on
position with the engine off.

4. Turn the hazard flashers on then
off three times. This must be
accomplished within 10 seconds.

If the reset mode has been entered successfully, the horn will sound
once, the TPMS indicator

will flash and the message center (if

equipped) will display TRAIN LEFT FRONT TIRE. If this does not
occur, please try again starting at Step 2.

If after repeated attempts to enter the reset mode, the horn does not
sound, the TPMS indicator

does not flash and the message center (if

equipped) does not display TRAIN LEFT FRONT TIRE, seek service
from your authorized dealer.

5. Train the TPMS sensors in the tires using the following TPMS reset
sequence starting with the left front tire in the following clockwise
order:
• Left front (Driver’s side front tire)
• Right front (Passenger’s side front tire)
• Right rear (Passenger’s side rear tire)
• Left rear (Driver’s side rear tire)

Tires, Wheels and Loading

253

2012 F-150 (f12)
Owners Guide, 1st Printing
USA
(fus)

This manual is related to the following products: