beautypg.com

Driver controls – FORD 2012 F-150 Raptor v.1 User Manual

Page 120

background image

3. To input these positions into the
Car2U

௡ system, simultaneously

press all three Car2U

௡ system

buttons for a few seconds and then
release to put the device into
programming mode. The indicator
lights will blink slowly. Within
2.5 minutes enter your
corresponding DIP switch settings
from left to right into your Car2U

௡ system by pressing and releasing the

buttons corresponding to the settings you circled.

4. After inputting switch settings, simultaneously press and release all
three Car2U

௡ system buttons. The indicator lights will turn on.

5. Press and hold the Car2U

system button you would like to use
to control the garage door.
Immediately (within 1 second)
release the button once the garage
door moves. During this time the
selected button indicator light will
blink slowly. Do not release the
button until you see the garage door move. Most garage doors open
quickly. You may need to hold the button from 5–55 seconds before
observing movement of the garage door.

6. The indicator light will (begin to) blink rapidly until programming is
complete. If your garage door opener does not operate following these
steps, repeat Steps 2 through 6. Otherwise, call the toll-free Car2U

௡ help

line at 1-866-57Car2U (1-866-572-2728).

After successful programming, you will be able to operate your Car2U

system by pressing the button you programmed to activate the opener.
The indicator light above the selected button will turn on to confirm that
the Car2U

௡ system is responding to the button command.

Driver Controls

120

2012 F-150 (f12)
Owners Guide, 1st Printing
USA
(fus)

This manual is related to the following products: