beautypg.com

Maintenance, Ab c d – FORD 2013 Fusion Hybrid v.2 User Manual

Page 252

background image

normal condensation occurs, a thin film of
mist can form on the interior of the lens.
The thin mist eventually clears and exits
through the vents during normal operation.
Clearing time may take as long as 48 hours
under dry weather conditions.

Examples of acceptable condensation are:

Presence of thin mist (no streaks, drip
marks or droplets).

Fine mist covers less than 50% of the
lens.

Examples of unacceptable moisture
(usually caused by a lamp water leak) are:

Water puddle inside the lamp.

Large water droplets, drip marks or
streaks present on the interior of the
lens.

Take your vehicle to a dealer for service if
any of the above conditions of
unacceptable moisture are present.

Replacing the Headlamp Bulbs

WARNING

Handle a halogen headlamp bulb
carefully and keep out of children’s
reach. Grasp the bulb by only its

plastic base and do not touch the glass.
The oil from your hand could cause the
bulb to break the next time the headlamps
are operated.

Note: If the bulb is accidentally touched, it
should be cleaned with rubbing alcohol
before being used.

A

B

C

D

E159753

Headlamp assembly:

A. Side marker lamp bulb

B. High beam headlamp bulb

C. Low beam headlamp bulb

D. Front parking/Turn signal lamp bulb

Replacing the High Beam Headlamp
Bulb

1.

Remove the headlamp assembly.

2. Remove the service cap.

3. Disconnect the electrical connector.

4. Turn the bulb counterclockwise and

remove it from the headlamp
assembly.

5. Install the new bulb in reverse order.

Replacing the Low Beam Headlamp
Bulb

1.

Remove the headlamp assembly.

2. Remove the service cap.

3. Disconnect the electrical connector.

4. Release the retainer spring and remove

it from the headlamp assembly.

5. Install the new bulb in reverse order.

Replacing the Front Parking/Turn
Signal Lamp Bulb

1.

Remove the headlamp assembly.

249

Maintenance