FORD 2013 F-150 v.3 - Manual (Page 74)

Programming/Changing Optional Settings
Use the information display to access your configurable MyKey settings.
For Type 1 information display settings
1. Switch the ignition on using an admin key.
2. Press SETUP until RESET FOR MYKEY SETTINGS is displayed.
3. Press and release RESET to display MyKey setup menus.
4. Press SETUP to display the next menu and scroll through your
choices.
5. On any of the menus, press RESET to highlight your choice by using
either of the arrow buttons: < or >.
6. Press SETUP to select your choice. The next configurable setting
will be displayed.
7. Repeat Steps 5 and 6 until you are done changing your configurable
settings.
For Type 2 information display settings
1. Switch the ignition on using an admin key.
2. Access the main menu and select Settings, then MyKey.
3. Use the arrow buttons < or > to get to a configurable feature.
4. Press OK or > to scroll through settings.
5. Press OK or > to make a selection.
CLEARING ALL MYKEYS
You can clear all MyKeys within the same key cycle as you created the
MyKey. If you switch your ignition off, however, you will need to use an
admin key to clear your MyKeys.
Note: When you clear your MyKeys, you remove all restrictions and
return all MyKeys to their original admin key status at once.
To clear all MyKeys of all MyKey settings, use the information display to
do the following:
For Type 1 information display settings:
1. Access the main menu of your information display and press SETUP
until PRESS RESET TO CLEAR MYKEY displays.
2. Press and release the RESET button. The display will show HOLD
RESET TO CONFIRM CLEAR.
3. Press and hold the RESET button for two seconds until ALL
MYKEYS CLEARED displays.
MyKey 73
2013 F-150 (f12)
Owners Guide gf, 3rd Printing, February 2013
USA (fus)