FORD 2013 F-150 v.3 - Manual (Page 73)

• Vehicle speed minders of 45, 55 or 65 mph (75, 90 or 105 km/h). Once
you select a speed, it will be shown in the display, followed by an
audible tone when the preselected vehicle speed is exceeded.
• Audio system maximum volume of 45%. A message will be shown in
the display when you attempt to exceed the limited volume. Also, the
speed-sensitive or compensated automatic volume control will be
disabled.
• Always on setting. When this is selected, you will not be able to turn
off Advance Trac, 911 Assist or the do not disturb feature (if your
vehicle is equipped with these features).
CREATING A MYKEY
Use the information display to create a MyKey.
For Type 1 information displays:
1. Insert the key you want to program into the ignition.
2. Switch the ignition on.
3. Access the main menu within the information display, and press
SETUP using the information display button until PRESS RESET
TO CREATE MYKEY displays.
4. Press and release the RESET button. The message HOLD RESET
TO CONFIRM MYKEY will display.
5. Press and hold the RESET button for two seconds until MARK
THIS AS RESTRICTED displays. Wait until KEY RESTRICTED
AT NEXT START displays, confirming that your key is successfully
created.
Make sure you label your key so you can distinguish it from the admin
keys.
For Type 2 information display controls:
1. Insert the key you want to program into the ignition.
2. Switch the ignition on.
3. From the main menu within the information display, use the right
arrow key > or OK to select SETTING and then MYKEY.
4. Press > or OK to select CREATE MYKEY.
5. Hold OK as prompted until you see MARK THIS KEY AS
RESTRICTED in the information display screen.
The key is successfully created. Make sure you label it so you can
distinguish it from the admin keys.
You can also program configurable settings for the key(s). Refer to the
Programming/Changing Optional Settings section .
72 MyKey
2013 F-150 (f12)
Owners Guide gf, 3rd Printing, February 2013
USA (fus)