beautypg.com

Engine coolant check, Checking the engine coolant, Adding engine coolant – FORD 2013 Edge v.2 User Manual

Page 279: Maintenance 279

background image

ENGINE COOLANT CHECK

Checking the Engine Coolant

The concentration and level of engine coolant should be checked at the
intervals listed in Scheduled Maintenance Information.

Note: Make sure that the level is between the COLD FILL RANGE marks
on the coolant reservoir.

Note: Coolant expands when it is hot. The level may extend beyond the
upper COLD FILL RANGE mark.

Note: If the level is at the lower COLD FILL RANGE mark, below the
lower COLD FILL RANGE mark, or empty, add coolant immediately. See
Adding Engine Coolant in this chapter.

The coolant concentration should be maintained at 50%.

Note: For best results, coolant concentration should be tested with a
refractometer such as Rotunda tool ROB75240 available from your
dealer. Ford does not recommend the use of hydrometers or coolant test
strips for measuring coolant concentrations.

Note: Automotive fluids are not interchangeable; do not use engine
coolant/antifreeze or windshield washer fluid outside of its specified
function and vehicle location.

Adding Engine Coolant

WARNING: Do not add engine coolant when the engine is hot.
Steam and scalding liquids released from a hot cooling system

can burn you badly. Also, you can be burned if you spill coolant on hot
engine parts.

WARNING: Do not put engine coolant in the windshield washer
fluid container. If sprayed on the windshield, engine coolant

could make it difficult to see through the windshield.

WARNING: To reduce the risk of personal injury, make sure the
engine is cool before unscrewing the coolant pressure relief cap.

The cooling system is under pressure; steam and hot liquid can come
out forcefully when the cap is loosened slightly.

Maintenance

279

2013 Edge (edg)
Owners Guide gf, 2nd Printing
USA
(fus)