FORD 2014 Taurus v.1 - Manual (Page 41)

Deactivating and Activating the Belt-Minder® Feature
WARNING: While the design allows you to deactivate your
Belt-Minder, this system is designed to improve your chances of
being safely belted and surviving an accident. We recommend you leave
the Belt-Minder system activated for yourself and others who may use
your vehicle. To reduce the risk of injury, do not deactivate or activate
the Belt-Minder feature while driving your vehicle.
Note: You can activate and deactivate the driver and front passenger
Belt-Minder independently. When deactivating or activating one seating
position, do not buckle the other position as this will terminate the
process.
Read Steps 1 - 5 thoroughly before proceeding with the programming
procedure.
Note: If you are using MyKey, you cannot disable Belt-Minder. Also, if
the Belt-Minder has been previously disabled, it will be re-enabled during
the use of MyKey. See the MyKey chapter.
You can activate and deactivate this feature by performing the following
procedure:
Before following the procedure, make sure that:
• the parking brake is set.
• the transmission selector lever is in position P.
• the ignition is off.
• the driver and front passenger safety belts are unbuckled.
1. Switch the ignition on. Do not start the engine.
2. Wait until the safety belt warning light turns off (about one minute).
3. Wait 10 seconds after the safety belt warning light turns off.
• Step 4 must be completed within 20 seconds after the completion of
Step 3.
4. Buckle then unbuckle the safety belt three times at a moderate speed,
ending in the unbuckled state.
• After Step 4, the safety belt warning light will turn on for three
seconds.
40 Safety Belts
2014 Taurus
Owners Guide gf, 1st Printing, April 2013
USA (fus)