beautypg.com

System errors, Switching the systems off and on, Collision warning system (if equipped) – FORD 2014 Taurus v.1 User Manual

Page 231: Collision warning system, 230 driving aids

background image

System Errors

If either system senses a problem with the left or right sensor, the
BLIS® indicator in the information display will illuminate and remain on.
Also, BLIND SPOT SYSTEM FAULT or CROSS TRAFFIC SYSTEM
FAULT
message will appear. When problems that may cause the left or
right indicator not to illuminate, only the information display message
faults appear.

Switching the Systems Off and On

One or both systems can be switched off temporarily by using the
information display control; refer to the Information Display chapter.
When the BLIS® is switched off, the driver does not receive alerts and
the information display shows BLIND SPOT SYS OFF and/or CTA
SYSTEM OFF. The system switches back on whenever the ignition is
switched on.

One or both systems can also be switched off permanently at your
authorized dealer. Once switched off, switching it back on must also be
done at the dealership.

COLLISION WARNING SYSTEM (IF EQUIPPED)

WARNING: This system is designed to be a supplementary
driving aid. It is not intended to replace the driver’s attention,

and judgment, or the need to apply the brakes. This system does NOT
activate the brakes automatically. Failure to press the brake pedal to
activate the brakes may result in a collision.

WARNING: The collision warning system with brake support
cannot help prevent all collisions. Do not rely on this system to

replace driver judgment and the need to maintain distance and speed.

Note: The system does not detect, warn or respond to potential
collisions with vehicles to the rear or sides of the vehicle.

Note: The collision warning system is active at speeds above
approximately 5 mph (8 km/h).

230

Driving Aids

2014 Taurus
Owners Guide gf, 1st Printing, April 2013
USA
(fus)