Lamps, Parking lamps/low beams, La mp s – BMW 330Ci Coupe 2006 User Manual

Page 92

Lamps

Parking lamps/low beams

0 Lamps off and daytime running light
1 Parking lamps and daytime running light
2 Low-beam headlamps and welcome lamps
3 Automatic headlamp control

, daytime run-

ning light, welcome lamps and Adaptive
Head Light

Parking lamps

In switch position

1, the front, rear and side

vehicle lighting is switched on. You can use the
parking lamps for parking.

The parking lamps will discharge the bat-
tery. Therefore, do not leave them on for

unduly long periods of time, otherwise the bat-
tery might not have enough power to start the
engine. It is preferable to switch on the left-
hand or right-hand roadside parking lamps,
refer to page

Low beams

The low beams light up when the light switch is
in position

2 and the ignition is on.

If the light switch remains in position

2, the

exterior lamps are switched off automatically
when the driver's door is opened while the igni-
tion is off.
If necessary, switch on the parking lamps as
described in the section about parking lamps.

Automatic headlamp control*

If the daytime running light is activated, refer to
page

, it is switched on when the light switch

is in position

3 and the ignition is on. Depending

on ambient light conditions, the low beams are
switched on automatically, e.g. in a tunnel, in
twilight, or if there is precipitation. The LED next
to the symbol is illuminated when the low
beams are on.
When driving into tunnels with bright overhead
lights, there may be a delay before the head-
lamps come on.
The headlamps may also come on when the
sun is sitting low on a blue sky.

The low beams remain switched on inde-
pendent of the ambient lighting condi-

tions when you switch on the fog lamps.

If desired, the light switch can remain in position
3. The exterior lamps are automatically
switched off after the vehicle is parked.

The automatic headlamp control cannot
serve as a substitute for your personal

judgment in determining when the lamps
should be switched on in response to ambient
lighting conditions. For example, the system
cannot detect fog or hazy weather. To avoid
safety risks, you should always switch on the
low-beam headlamps manually under these
conditions.

Adjusting sensitivity

You can program how sensitively the system
reacts to ambient light.
iDrive, for operating principle refer to page

Press the

button.

This opens the start menu.

Press the controller to open the menu.

Select "Vehicle settings" and press the
controller.

ba8_E9293_US.book Seite 90 Freitag, 5. Mai 2006 1:02 13