Starting engine, Switching engine off, Driving – BMW 650i Convertible 2007 User Manual
Page 62
Driving
60
Starting engine
Do not run the engine in closed rooms,
otherwise the inhalation of toxic exhaust
gases can cause unconsciousness and death.
The exhaust gases contain carbon monoxide,
an odorless and colorless, but highly toxic gas.
Never leave an unattended vehicle with the
engine running, as such a vehicle represents a
potential safety hazard.
Before leaving the vehicle with the engine run-
ning, shift into neutral or move the selector lever
into position P and firmly apply the handbrake,
otherwise the vehicle can begin to roll.
<
Do not allow the engine to warm up by leaving it
running while the vehicle remains stationary.
Instead, drive off at a moderate engine speed.
Avoid frequent starting in quick succes-
sion or repeated starting attempts in
which the engine does not start. Otherwise, the
fuel is not burned at all or is burned inade-
quately and there is a danger of overheating and
damage to the catalytic converter.
<
Manual transmission
Remote control in ignition lock or with comfort
access in vehicle, refer to page
.
1.
Depress brake pedal.
2.
Depress the clutch pedal and select the
idling position.
3.
Press the Start/Stop button.
Automatic transmission*
Remote control in ignition lock or with comfort
access in vehicle, refer to page
.
1.
Depress brake pedal.
2.
Place selector lever in position P or N.
3.
Press the Start/Stop button.
SMG Sequential Manual
Transmission*
Remote control in ignition lock or with comfort
access in vehicle, refer to page
1.
Depress brake pedal.
2.
Move selector lever into position N and
make sure that this position is also indi-
cated in instrument cluster.
3.
Press the Start/Stop button.
If the engine fails to start, depress the
brake pedal and press the selector lever
to the right and then back into position N.
Watch the display in the instrument cluster
while doing so.
<
Switching engine off
When leaving the vehicle, always take the
remote control with you.
When parking, firmly apply the handbrake, as
otherwise the vehicle could roll.
<
Manual transmission
1.
Press the Start/Stop button with the vehicle
stopped.
2.
Shift into first gear or reverse.
3.
Firmly apply the handbrake.
4.
Remove the remote control from the igni-
tion lock, refer to page
.
SMG Sequential Manual
Transmission*
1.
Firmly apply the handbrake.
2.
Move selector lever into a drive position.
3.
Press the Start/Stop button.
If N is engaged when switching off the
engine, this will be pointed out to you opti-
cally and acoustically.
4.
Remove the remote control from the igni-
tion lock, refer to page
.
Online Edition for Part no. 01 41 0 013 312 - © 02/07 BMW AG