Speed limit – BMW M6 Convertible 2009 User Manual
Page 79
77
5.
Change to upper field if necessary. Turn the
controller until "Check Control messages"
is selected and press the controller.
6.
Select a message and press the controller.
To exit from the menu immediately:
Select the
arrow and press the controller.
Displaying the urgency of malfunctions
Depending on the equipment, the stored Check
Control messages are also displayed with the
following symbols:
No malfunctions detected in the moni-
tored systems.
Malfunctions are present in the moni-
tored systems. Depending on the mal-
function, supplementary information is
shown on the Control Display.
The symbols also indicate the status of the ser-
vice requirements display, refer to page
.
Displays after completion of trip
Malfunction reports generated during the trip
are shown consecutively when you switch off
the ignition.
Before the display disappears, you can display
the messages once again. Press the CHECK
button for approx. 2 seconds. If several mes-
sages are present, you can continue to press
the CHECK button to view them in succession.
The display goes out:
>
after a short time
>
when you press the CHECK button again
for approx. 2 seconds
Speed limit
You can enter a speed and a Check Control
message indicates when you have reached this
speed. This enables you, for example, to
receive warnings if you exceed a speed limit in
an urban area.
You are only warned of reaching this speed a
second time if your vehicle speed falls below it
again by at least 3 mph/5 km/h.
Displaying, setting or changing limit
iDrive, for operating principle refer to page
1.
Open the start menu.
2.
Open "Navigation".
Without navigation system
*
: Open "Car
Data".
3.
Select "Car Data" and press the controller.
4.
Select "Limit" and press the controller.
Online Edition for Part no. 01 41 2 600 775 - © 08/08 BMW AG