Starting engine, Switching off engine, Driving – BMW X6 xDrive50i 2009 User Manual
Page 68
Driving
66
The ignition switches off automatically
*
if the
driver's door is opened. Pressing the start/stop
button again switches the ignition back on.
For example, the ignition is not switched off in
the following situations:
>
the brakes are actuated
>
the low beams are switched on
Starting engine
Do not run the engine in closed rooms,
otherwise the inhalation of toxic exhaust
gases can cause unconsciousness and death.
The exhaust gases contain carbon monoxide,
an odorless and colorless, but highly toxic gas.
Never leave an unattended vehicle with the
engine running, as such a vehicle represents a
potential safety hazard.
To prevent the vehicle from rolling, always
engage transmission position N or P and set the
parking brake before leaving the vehicle with
the engine running.
<
Do not allow the engine to warm up by leaving it
running while the vehicle remains stationary.
Instead, begin to drive at a moderate engine
speed.
The engine starts when you depress the
brake pedal while pressing the Start/Stop
button.
<
Avoid frequent starting in quick succes-
sion or repeated starting attempts in
which the engine does not start. Otherwise, the
fuel is not burned or inadequately burned and
there is a danger of overheating and damaging
the catalytic converter.
<
Remote control in ignition lock or with comfort
access in vehicle, refer to page
1.
Depress brake pedal.
2.
Press the Start/Stop button.
The system responds by automatically engag-
ing the starter for a certain period and automat-
ically disengaging it as soon as the engine
starts.
Diesel engine
When the engine is cold and outside tempera-
tures are below approx. 32
7/06, the starting
process may be briefly delayed by an automatic
preglow phase. The preglow indicator lamp
lights up in the instrument panel and a message
appears on the Control Display.
Switching off engine
When leaving the vehicle, always take
along the remote control.
Set the parking brake firmly when parking; oth-
erwise, the vehicle could roll.
<
Procedure
1.
Engage transmission position P with the
vehicle stationary.
2.
Press the Start/Stop button.
3.
Set the parking brake.
4.
Remove the remote control from the igni-
tion lock, refer to page
.
Before driving into a car wash
The vehicle can roll if you proceed according to
the following steps:
1.
With comfort access
*
: insert the remote
control into the ignition lock.
2.
Depress brake pedal.
3.
Engage transmission position N.
4.
Release the parking brake or deactivate
Automatic Hold.
5.
Switch off the engine.
Online Edition for Part no. 01 41 2 600 809 - © 09/08 BMW AG