Speed limit, Stopwatch – BMW 650i Convertible 2009 User Manual

Page 85

Displaying the urgency of malfunctions

Depending on the equipment, the stored Check
Control messages are also displayed with the
following symbols:

No malfunctions detected in the moni-
tored systems.
Malfunctions are present in the moni-
tored systems. Depending on the mal-
function, supplementary information is
shown on the Control Display.

The symbols also indicate the status of the ser-
vice requirements display, refer to page

Displays after completion of trip

Malfunction reports generated during the trip
are shown consecutively when you switch off
the ignition.
Before the display disappears, you can display
the messages once again. Press the CHECK
button for approx. 2 seconds. If several mes-
sages are present, you can continue to press
the CHECK button to view them in succession.
The display goes out:

after a short time

when you press the CHECK button again
for approx. 2 seconds

Speed limit

You can enter a speed and a Check Control
message indicates when you have reached this
speed. This enables you, for example, to
receive warnings if you exceed a speed limit in
an urban area.
You are only warned of reaching this speed a

second time if your vehicle speed falls below it
again by at least 3 mph/5 km/h.

Displaying, setting or changing limit

iDrive, for operating principle refer to page

Open the start menu.

Open "Navigation".
Without navigation system

: Open "Car

Data".

Select "Car Data" and press the controller.

Select "Limit" and press the controller.

Select the speed value and press the con-
troller.

Turn the controller to set the limit.

Press the controller to apply the setting.
The limit is activated.

Applying your current speed as limit

Select "Select current speed" and press the
controller. The system adopts your current
speed as the limit.

Activating/deactivating limit

Select "On" and press the controller.

The limit is activated.

Stopwatch