Replacing components – BMW M6 Convertible 2010 User Manual
Page 208
Replacing components
206
Model with pressure gauge on hose*
3 Connector and cable for lighter socket
4 Mounting for sealing bottle
5 Compressor
6 On/Off switch
7 Pressure gauge for indicating tire inflation
pressure
8 Screw on pressure gauge for reducing tire
inflation pressure
9 Connecting hose for connecting compres-
sor and sealant bottle or compressor and
wheel
Connector, cable and connecting hose are
stored in the compressor housing.
Model with pressure gauge integrated
in housing*
3 Connector and cable for lighter socket
4 Mounting for sealing bottle
5 Compressor
6 On/Off switch
7 Pressure gauge for indicating tire inflation
pressure
8 Button for reducing tire inflation pressure
9 Connecting hose for connecting compres-
sor and sealant bottle or compressor and
wheel
Connector, cable and connecting hose are
stored on underside of compressor.
Using M Mobility System
To repair a flat tire with the M Mobility System,
proceed as follows:
>
Fill sealant into wheel, refer to page
206
.
>
Distribute sealant, refer to page
207
.
>
Produce tire inflation pressure, refer to
page
207
.
Filling sealant into wheel
Strictly comply with the specified order,
otherwise highly pressurized sealant
could escape.
<
1.
Shake sealant bottle.
2.
Screw hose
9 onto connection of sealant
bottle.
3.
For model with pressure gauge on hose:
Make sure that screw
8 on pressure gauge
is closed.
4.
Screw dust cap off valve of defective wheel
and screw filling hose
2 of sealant bottle
onto valve.
5.
Insert sealant bottle on compressor hous-
ing so that it is positioned upright.
6.
Make sure that the device is switched off,
position 0.
7.
Insert connector
3 into lighter socket in
vehicle interior, refer to page
8.
With the ignition switched on, refer to
page
:
Online Edition for Part no. 01 41 2 602 735 - © 08/09 BMW AG
Online Edition for Part no. 01 41 2 602 735 - © 08/09 BMW AG