BMW 650i Convertible 2010 User Manual

Page 97

Any improvement in detection depends on
many factors such as the object size and tem-
perature compared to the surroundings, or
other nearby objects, the visual recognition
skills of the driver, weather conditions, and
other factors.

Driving hints

With the system active, periodically but briefly,
glance at the thermal image on the Control Dis-
play to notice objects that could be people or
larger animals. The glance should be similar to
glancing at the rear view mirror. Do not stare at
the image for long periods while driving, as this
will remove attention from the road. If you notice
an object of interest ahead, be prepared to slow
down or stop, blow the horn, or take other
appropriate action.

System limits

The system is designed to supplement but not
replace forward vision through the windshield.
The driver is responsible for safe driving at
night. BMW Night Vision is not designed to be
used as a continuous viewing window for driv-
ing at night.

No system, no matter how sophisticated, can
operate without limitations. BMW Night Vision
operation is subject to physical and environ-
mental limitations that will reduce the ability of
the system to detect and display a clear thermal
image. Some of the situations in which these
limitations can occur are:

on steep hilltops or depressions and in tight
curves

in tunnels, as the contrast is inherently low

when the camera lens is dirty

in dense fog, heavy rain or snowfall

when displaying very hot objects such as
transformers, car exhausts etc.

when the image briefly freezes during nor-
mal system adjustment.

BMW Night Vision's potential benefits
can be limited by the driving style of the

driver, the size and relative temperature of the
detected objects, dirt or contamination on the
camera lens, adverse weather like snow, rain or
fog, and other factors not mentioned here. It will
always be the driver's responsibility to drive at a
speed and in a manner that recognizes potential
hazards and adjust accordingly.
BMW Night Vision is not a substitute or replace-
ment for the driver's responsibility to adapt to
visibility and traffic conditions. The forward view
illuminated by the headlamps must always be
the basis for making safe driving decisions, oth-
erwise a safety risk will result.

Activating BMW Night Vision

Turn the light switch to position

2 or 3, refer

to page

With low beams switched on:

Press the

button. Depending on the

vehicle's equipment, the location of the
button may differ somewhat.

The image is displayed on the Control Display
after a few seconds. Depending on the last
mode selected, either the normal or full screen
image is displayed.

This manual is related to the following products:

650i Coupe 2010