BMW 335i xDrive Sedan 2014 User Manual
Page 98
All wheels green
System is active and will issue a warning rela‐
tive to the tire inflation pressures stored during
the last reset.
One wheel is yellow
A flat tire or major drop in inflation pressure in
the indicated tire.
All wheels are yellow
A flat tire or major drop in inflation pressure in
several tires.
Wheels, gray
The system cannot detect a flat tire. Reasons
for this may be:
▷
The system is being reset.
▷
Malfunction.
Carry out reset
Reset the system after each adjustment of the
tire inflation pressure and after every tire or
wheel change.
1.
"Vehicle Info"
2.
"Vehicle status"
3.
"Perform reset"
4.
Start the engine - do not drive away.
5.
Carry out the reset with "Perform reset".
6.
Drive away.
The tires are shown in gray and the status is
displayed.
After driving faster than 19 mph/30 km/h for a
short period, the tire inflation pressures set are
accepted as reference values. The reset is
completed automatically during driving.
After a successfully completed Reset, the
wheels on the Control Display are shown in
green and "Tire Pressure Monitor (TPM)
active" is displayed.
The trip can be interrupted at any time. If you
drive away again, the reset resumes automati‐
cally.
Low tire pressure message
The yellow warning lamp lights up. A
Check Control message is displayed.
▷
There is a flat tire or a major loss in
tire inflation pressure.
▷
No reset was performed for the system.
The system therefore issues a warning
based on the tire inflation pressures before
the last reset.
1.
Reduce your speed and stop cautiously.
Avoid sudden braking and steering maneu‐
vers.
2.
Check whether the vehicle is fitted with
regular tires or run-flat tires.
Run-flat tires, refer to page
beled with a circular symbol containing the
letters RSC marked on the tire sidewall.
Do not continue driving without run-flat
tires
Do not continue driving if the vehicle is not
equipped with run-flat tires; continued driving
may result in serious accidents.◀
When a low inflation pressure is indicated,
DSC Dynamic Stability Control is switched on
if necessary.
Actions in the event of a flat tire
Normal tires
1.
Identify the damaged tire.
Do this by checking the air pressure in all
four tires.
If the tire inflation pressure in all four tires
is correct, it is possible that a reset was not
carried out for the Tire Pressure Monitor.
Then perform the reset.
Seite 98
Controls
Safety
98
Online Edition for Part no. 01 40 2 925 743 - II/14