BMW 335i xDrive Sedan 2014 - Manual (Page 212)

Replacing the reversing lamp and inner
brake lamp
1. Loosen the two holders, arrow 1 and pull
down on the lamp holder to remove, ar‐
row 2.
2. Unscrew the defective bulb of the revers‐
ing or brake lamp from its socket counter‐
clockwise.
3. Insert the new bulb.
Installing the bulb holder
1. Slide the bulb holder onto the two guide
pins, arrow 1. Insert the two contacts, ar‐
row 2, into the connections, arrow 3.
2. Press on the bulb holder. Make sure that
the two exterior holders latch into place.
3. Swing the trim back onto the trunk lid and
secure.
Tail lamp, license plate lamp and
central brake lamp
Follow general instructions, refer to page 204 .
These lamps are made using LED technology.
Contact your service center in the event of a
malfunction.
Changing wheels
Hints
The vehicle equipment does not include a
spare tire.
When using run-flat tires or tire sealants, a tire
does not need to be changed immediately in
the event of pressure loss due to a flat tire.
The tools for changing wheels are available as
accessories from your service center.
Jacking points for the vehicle jack
The jacking points for the vehicle jack are lo‐
cated at the positions shown.
Vehicle battery
Maintenance
The battery is maintenance-free.
The added amount of acid is sufficient for the
service life of the battery.
Your service center will be glad to advise you
on questions regarding the battery.
Battery replacement
Use approved vehicle batteries only
Only use vehicle batteries that have been
approved for your vehicle by the manufacturer;
otherwise, the vehicle could be damaged and
systems or functions may not be fully availa‐
ble.◀
Seite 212
Mobility Replacing components
212
Online Edition for Part no. 01 40 2 925 743 - II/14