BMW 335i xDrive Sedan 2014 User Manual
Page 208
Daytime running lights
24-watt bulb, PW24W.
1.
If necessary, remove the high beam bulb
connector.
2.
Remove the bulb holder.
3.
Remove the bulb from the bulb holder.
4.
To insert the new bulb, proceed in reverse
order of removal. During insertion, the bot‐
tom of the bulb holder must be facing
downward. Make sure that the bulb holder
snaps into place.
5.
Attach the high beam bulb connector.
6.
Close the headlamp housing with the cap.
Make sure that the cap engages.
Xenon headlamps
Xenon headlamps
Because of the long life of these bulbs, the
likelihood of failure is very low. Switching the
lamps on and off frequently shortens their life.
If a bulb fails, switch on the front fog lamps and
continue the trip with great care. Comply with
local regulations.
Do not perform work/bulb replacement
on xenon headlamps
Have any work on the xenon lighting system,
including bulb replacement, performed only by
a service center. Due to the high voltage
present in the system, there is the danger of
fatal injuries if work is carried out improperly.◀
For checking and adjusting headlamp aim,
please contact your BMW center.
Headlamps
1 Parking lamps / daytime running lights
2 Low beams/high beams/headlamp flasher
3 Turn signal
Low beams and high beams are designed with
xenon technology.
The parking lamps and daylight running lights
are made using LED technology.
Contact your service center in the event of a
malfunction.
Turn signal
Follow general instructions, refer to page
Seite 208
Mobility
Replacing components
208
Online Edition for Part no. 01 40 2 925 743 - II/14