BMW 335i xDrive Sedan 2014 - Manual (Page 206)

In the wheel house, loosen the two brackets
and remove the cover.
Turn signal
21-watt bulb, PY21W
1. If necessary, pull the inside trim of the
wheel house slightly inward. Turn the bulb
holder counterclockwise and remove.
2. Press the bulb gently into the socket, turn
counterclockwise and remove.
3. Install the new bulb and bulb holder in re‐
verse order of removal.
4. Attach the cover to the wheel house.
Low beams
55-watt bulb, H7.
1. Turn the cap counterclockwise and re‐
move.
2. Tilt the bulb down and then up to loosen it
from the holder and remove.
3. Pull the connector off the bulb.
4. Attach the connector to the new bulb.
5. First insert the bulb at the top with the
strap, arrow 1, and then press down firmly,
arrow 2. Make sure that the bulb snaps into
place.
6. Close the headlamp housing with the cap.
Make sure that the cap engages.
7. Attach the cover to the wheel house.
Seite 206
Mobility Replacing components
206
Online Edition for Part no. 01 40 2 925 743 - II/14