Freedom Designs TriPod LT - Manual (Page 5)

3
General Warnings
Warnings & Caution statements included in this manual describe conditions and unsafe
practices which might result in bodily injury or property damage. Read this entire manual
before assembly or operation of this wheelchair. If you do not understand any of the
instructions in this manual, call your authorized Freedom Designs, Inc. dealer. Note: Where
they apply, you will also find “Warnings” in other sections of this manual. Heed all warnings in
this section.
If you fail to heed these warnings, damage to your chair, a fall, tip-over or loss of control
may occur and cause severe injury to the rider or others
The weight limit for the TriPod ™
LT
is a 200 lb. person. If the person ex-
ceeds the weight limit, damage to your chair, a fall, tip-over or loss of control
may cause severe injury to the rider or others.
Every wheelchair is different.
Become familiar with your chair before you
begin riding. Start slowly, with easy, smooth strokes. Be careful not to use too
much force, which might result in tipping over, damage to your chair, a fall or
loss of control, which may occur and cause severe injury to the rider or others.
Reduction of Risk of an Accident:
1. BEFORE riding, you should be trained in the safe use of this chair by your
health care advisor.
2. Practice bending, reaching and transfers until you know the limit of your
ability. In order to avoid tipping over, have someone help you, until you
know what can cause a fall.
3. Be aware that you must develop your own methods for safe use best suited
to your level of function and ability.
4. NEVER try a new maneuver on your own, until you are sure you can do it
safely.
5. Get to know the areas where you plan to use your chair. Look for hazards
and learn how to avoid them.
If you fail to heed these warnings, damage to your chair, a fall, tip-over or
loss of control may occur and cause severe injury to the rider or others.
Safety Checklist
Before each use of your chair:
1. Make sure the chair rolls easily and that all parts work smoothly. Check for
noise, vibration, or a change in ease of use. (They may indicate low tire
pressure, loose fasteners, or damage to your chair).
2. Repair any problems. Consult your Freedom Designs, Inc. authorized
dealer for help in finding or correcting the problem.
3. Check to see that both quick-release axles are locked. When locked, the
axle button will “pop out” fully. If not locked, the wheel may come off and
cause you to fall.
If you fail to heed these warnings, damage to your chair, a fall, tip-over or
loss of control may occur and cause severe injury to the rider or others.
W
A
R
N
I
N
G
!