FLO~PRO 301008 - Manual (Page 9)

STEP 20: Mount the supplied support bracket as seen
in Fig. 13. The back bolt screws into the
stand off bolt (G). Use the 1/4-20 bolt, nut,
washer to secure the trans dipstick to the
bracket. (Fig. 13)
STEP 21: Refill the coolant
to factory specs.
STEP 22: Installation is now complete! Start the engine
to circulate coolant. Top off as necessary and
inspect for leaks. Install the plastic engine
cover and you're done!
Install Bracket & Test
Fig. 13
Dipstick
Mount
Stand Off
Bolt Mount
Crank Case
Tube Mount
Coolant Hose
Adapter Slot
Exhaust Pressure
Tube Mount
Factory Coolant
Tube Mount
Bracket Diagram