FLO~PRO 301008 - Manual (Page 8)

Block EGR & Reassemble
STEP 17: Install the other (ported) exhaust block-off
plate on the back side of the exhaust
manifold. Be sure to reuse the factory
hardware. (Fig. 11)
STEP 18: Re-install the crankcase breather tube. Using
the new supplied coolant hose (C) and
adapter (D), connect the two coolant ports
that previously went to the EGR cooler and
secure with provided hose clamps.
STEP 19: Replace the manifold bolt with the supplied
stand off bolt (E). The bolt will be the third
bolt in from the back of the motor. The nut (F)
on the stand off bolt should be used as a jam
nut to secure it in place. (Fig. 12)
Fig. 11
Fig. 12