Removing bypass/servo, Fig. 6 fig. 7 – FLO~PRO 301008 User Manual

Page 6

background image

STEP 9:

Now that you've removed the heat shield,

remove the four 10mm bolts holding the

exhaust bypass in place. The bypass will be

removed with the servo in the next steps.

STEP 10:

Remove the five 10mm bolts securing the

EGR servo mounting bracket in place.

Simultaneously remove the EGR servo & the

exhaust bypass from the vehicle. (Fig. 6)

STEP 11:

Remove the crankcase breather tube that

runs over the EGR cooler. Also, disconnect

the two coolant lines that run to the EGR

cooler. Be sure to remove the O-Ring fitting

from the engine block. (Fig. 7) Remove the

four 10mm EGR cooler mounting bolts

(Circled Fig. 7).

STEP 12:

Remove the two 15mm nuts connecting to the

EGR cooler to the exhaust manifold near the

fire wall.

Removing Bypass/Servo

Fig. 6

Fig. 7

Bypass

Servo

Coolant Lines