FASS FA F17 220G - Manual (Page 16)

F. Using oil, insert PLB-1212 into one end of FL-1002 fuel line. Oil the PLB and slide into the yellow-
clipped factory feed fitting until you hear a click. Push down the locking tab.
Note: Secure all fuel lines with cable ties. Cable ties are an economical way to prevent the
possibility of problems occurring!
G. Disconnect both factory return lines from the factory lift pump (Refer to diagram at the beginning of
Step 2). Insert DB-4646 into each return line fitting until you hear a click and tabs lock.
H. Clean and cap off the factory return ports with the two RVC-38 caps. Clean and cap off the factory
feed port with the RVC-12 cap. Seal factory electrical connection with di-electric grease or similar to
prevent corrosion.