beautypg.com

FASS FA F17 220G User Manual

Page 10

background image

A.

Very Important: Before removing the fuel tank identify “ALL” areas of
clearance between the tank and bed to install the draw tube assembly.
The closer the suction tube is placed to the fuel sending unit, front to
back and left to right, the more usable fuel there will be!

Some of the photo’s are of a different application, procedures are the same.

B.

Remove the filler neck and overflow tubes from the truck by loosening
the clamps at both ends.

Helpful Hints: If more space is required to access the top of the

fuel tank, loosen the strap nuts to the end of the stud. This will

gain you about 3” more working room.

D.

With the fuel tank empty of fuel, unbolt the tank straps and remove it
from the vehicle.

E.

Clean the fuel module area then remove the lock ring on the top of the
fuel tank. This is spring loaded, so, holding it down while removing
the ring will prevent the sending unit from popping up and possi-
bly causing damage.

C.

Disconnect factory suction and return lines. Refer to diagram at the
beginning of Step 2

Helpful Hint: Directions for removing factory lines.

1.

Pull up on the locking tab (either blue or yellow),

2.

Push in slightly on the connector,

3.

Press down on the release tab,

4.

Pull the connector straight off,