FASS FA F17 220G - Manual (Page 11)

NOTE: Hose clamps are not recommended for push lock fittings.
They will hold up to 300psi! Use oil on fittings and inside fuel line
when installing Push-Lok fittings
G. Once the lock ring is removed, carefully remove pick up module from
fuel tank without bending fuel level arm.
F. Note the location of the tab and arrow. Re-install the sending unit in
the same location to prevent the fuel level arm from binding.
H. Place the tank on blocks to simulate the tank hanging. Failure to do
this step may result in the draw tube being cut too short.
J. Place the lock ring back on the tank and locate the BHF-1002 bulkhead fitting on the tank with enough
clearance for the fuel line and fittings. Keep in mind the bulkhead must also clear the bottom of the
bed support structure. The fiberglass protective shell will have to be trimmed as necessary for clear-
ance.
I. Assemble the BHF-1002 with a PL-1004 in ‘S’ using thread tape. In-
sert 1/2” brass plug into the ‘R’ port. Torque both to 40 lb./ft.² Push
the ST-1005P onto the barbed portion of the BHF-1002. Insert O-ring
into groove.