FASS T F17 200G - Manual (Page 11)

G. Once the lock ring is removed, carefully remove pick up module from
fuel tank without bending fuel level arm.
F. Note the location of the tab and arrow. Re-install the sending unit in
the same location to prevent the fuel level arm from binding.
H. VERY IMPORTANT: Support fuel tank on both ends allowing the
natural formation of the tank to take place. Failure to perform this step
can and will create an issue with less usable fuel!
J. Place the lock ring back on the tank and locate the BHF-1002 bulkhead fitting on the tank with enough
clearance for the fuel line and fittings. Keep in mind the bulkhead must also clear the bottom of
the bed support structure. The fiberglass protective shell will have to be trimmed as necessary for
clearance .
I. Assemble the BHF-1002 with the PL-1010 in port “S” & the PL-1004
in the “R” port using thread tape. Torque to 40 ft./lbs. Push the ST-
1005P onto the barb portion of the BHF-1002. Insert O-ring into
groove.