FASS T F17 200G - Manual (Page 10)

B. Remove the filler neck and overflow tubes from the truck by loosening
the clamps at both ends.
Some of the photo’s are of a different application, procedures are the same.
D. With the fuel tank empty of fuel, unbolt the tank straps and remove it
from the vehicle.
E. Clean the fuel module area then remove the lock ring on the top of the
fuel tank. This is spring loaded, so, holding it down while removing
the ring will prevent the sending unit from popping up and possi-
bly causing damage.
C. Disconnect factory suction and return lines (refer to diagram at the be-
ginning of step 2).
A. Before tank is removed or moved, identify ALL areas of clearance be-
tween the tank and the truck’s bed for the best location to install the
BHF assembly. With proper clearance, you want to install it as close to
the Fuel sending unit as possible.
Helpful Hint: Directions for removing factory lines.
1. Pull up on the locking tab (either blue or yellow),
2. Push in slightly on the connector,
3. Press down on the release tab,
4. Pull the connector straight off,