Warning – Dynalco Catalyst Monitor User Manual
Page 2
1
IMPORTANT - PLEASE READ BEFORE PROCEEDING!
This manual applies to all Version2 Catalyst Monitors.
The Dynalco Catalyst Monitor is designed for reliable and rugged operation on engines
with NSCR and oxidation catalysts. This product has been designed and tested to
meet the demands required in many industrial and hazardous locations meeting
critical CSA standards. The performance is directly related to the quality of the
installation and knowledge of the user in operating and maintaining the instrument. To
ensure continued operation to the design specifications, personnel should read this
manual thoroughly before proceeding with installation, operation and maintenance of
this instrument. If this product is used in a manner not specified by Dynalco, the
protection provided by it against hazards may be impaired.
WARNING
•
Failure to follow proper instructions may cause any one of the following
situations to occur: Loss of life; personal injury; property damage; damage to
this instrument; and warranty invalidation.
•
For clarification of instructions in this manual or assistance with your
application, contact Dynalco at (800) 368-6666 or (954) 739-4300 or send email to
•
Additional manuals and CSA certificates are available at
www.dynalco.com
•
Follow all warnings, cautions, and instructions marked on and supplied with the
product.
•
Use only qualified personnel to install, operate, program and maintain the
product.
•
Educate your personnel in the proper installation, operation, and maintenance of
the product.
•
Install equipment as specified in the installation section of this manual. Follow
appropriate local and national codes. Only connect the product to power
sources and end devices specified in this manual.
•
Any repair is only to be performed by Dynalco using factory documented
components. Tampering or unauthorized substitution of parts and procedures
can affect the performance and cause unsafe operation of your process.
•
All equipment doors must be closed and protective covers must be in place
unless qualified personnel are performing maintenance.
•
Shutdown / alarms should be tested monthly for proper operation (see page 14)
•
Please see page 22 for CSA specific installation instructions.