Dynalco Catalyst Monitor - Manual (Page 10)

9
Programming Instructions
Important: The Catalyst Monitor must first be programmed prior to operation.
When initially powering up the unit, the display will first indicate the firmware version and then
go to the operational mode. It may also display a screen warning that the time & date need to
be entered. This will be explained below.
To configure the Catalyst Monitor, first go to the main programming screen by pressing the
Menu / Escape key:
The following menu icons will appear from left to right:
Run Signal
- defines run status input type (if any)
Channel - enables each channel type and alarm thresholds
Calibration
- defines zero & span values for DCV & mA inputs
Alarm Settings
- for setting high /low alarm thresholds
Alarm Logs
- allows the user to view alarm status
Communication - Log Reader / Modbus setup
Data Logging - allows configuration of up to (10) different logging events
System - allows EPA enable & current date / time settings