Dogtra eF-3000 - Manual (Page 13)

25
TESTING
1. To ensure that your
is working properly, connect the transmitter
adaptor into the jack connector of the transmitter
and then plug the adaptor into a household
outlet. The ON/OFF indicator light should be on.
2. Unwind the length of ground wire that was
provided and strip about 1/2 inch off each end.
Insert one end of the ground wire into the first
wire connector jack and the other end into the
third, leaving the center jack free. If the wires are
connected properly, the wire indicator light will
be on.
TESTING YOUR
PRIOR TO INSTALLATION
24
3. Do not charge the batteries near any flammable
substances.
4. Fully charge the batteries for 14 hours if the
collar is to be stored without use for a period of
a month or more.
5. Recharge the battery if:
- the indicator light on the collar is emitting a
double blink every two seconds
- the indicator light on the receiver will not
come on
- the indicator light on the receiver comes on
momentarily but will not stay on
CHARGING THE RECEIVER/COLLAR