beautypg.com

Accustoming the dog to the beeper sound – Dogtra 2000B Series User Manual

Page 10

background image

17

ACCUSTOMINGTHEDOGTOTHEBEEPERSOUND

16

CHARGING THE BATTERY

BATTERY CHARGING

When the batteries need recharging, the

LED light will emit a rapid, double flash every
2 seconds. If the batteries have been allowed to
run completely down, the indicator light may
not come on at all.

Be sure to turn off the collar receiver

before charging.

To charge the batteries, connect the

single side of the splitter cable to the battery
charger. Connect one side of the splitter cable
into the collar/receiver and the other side into
the transmitter. Then, plug the charger into a
household outlet. Recharge batteries for 14
hours. (See battery charging diagram.)

Both the collar receiver and transmitter

indicator light will glow continuously while
the batteries are charging.

After disconnecting the cable, close the

receptacle covers. Be sure the rubber plugs are
completely sealed over the receptacle to
prevent dirt and water from entering.

ACCUSTOMING THE DOG TO
THE BEEPER SOUND

Turn on the beeper collar and leave it outside

the dog’s kennel area for about a half-hour.

Repeat this several times, until you can see

that the dog disregards the beeper.

Next, fill the speaker horn with tissue paper

to muffle the sound. Fit the beeper collar on the
dog. Gradually, remove some of the tissue paper
as the dog becomes accustomed to the beeping
sound.

Now, when you take him hunting, he will be

accustomed to the beeper sound.

This manual is related to the following products: