Canon EOS 50D - Manual (Page 107)

107
E-TTL II autoflash obtains high-precision and consistent flash shots.
If necessary, the built-in flash will pop-up automatically in low-light
or backlit conditions. (except in <3> <5> <7> modes)
Regardless of the light level, you can press the <D> button to pop-up
and fire the built-in flash whenever desired. If the built-in flash has
popped up, you can push it back down with your fingers.
d
: For fully automatic flash photography. The shutter speed (1/
250 sec. - 1/60 sec.) and aperture are set automatically.
s : Enables you to set the desired shutter speed (1/ 250 sec. -
30 sec.). The flash exposure will be set automatically to match
the aperture that was set automatically.
f : Enables you to set the desired aperture. The flash exposure
will be set automatically to match the aperture that was set. The
shutter speed will be set automatically between 1/250 sec. -
30 sec. to suit the scene’s brightness.
In low light, the main subject is exposed with the automatic
flash, and the background is exposed with a slow shutter speed
set automatically. Both the subject and background look
properly exposed (automatic slow-speed flash sync).
With slow shutter speeds, using a tripod is recommended.
If you do not want a slow shutter speed to be used, set
[8C.Fn I -7: Flash sync. speed in Av mode] to [1: 1/250-1/
60sec. auto] or [2: 1/250sec. (fixed)] (p.175).
a : You can set both the shutter speed (1/250 sec. - 30 sec.,
bulb) and aperture. The flash exposure will be set
automatically to match the aperture that was set. The
background exposure will vary depending on the shutter speed
and aperture.
8 : The flash result will be the same as the mode.
Using the Built-in Flash
Using the Built-in Flash in the Basic Zone
Using the Built-in Flash in the Creative Zone
COP
Y