Camera (optional), Removing the camera, Replacing the camera – Dell Inspiron 1545 User Manual
Page 12
Back to Contents Page
Camera (Optional)
Dell™ Inspiron™ 1545 Service Manual
Removing the Camera
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Remove the display panel (see
Removing the Display Panel
).
5.
Remove the four screws securing the brackets to the camera board.
6.
Remove the camera board brackets.
7.
Disconnect the camera cable from the connector on the camera board.
8.
Remove the camera board.
Replacing the Camera
1.
Align the camera board over the screw holes.
2.
Replace the camera board brackets.
3.
Replace the four screws that secure the camera board brackets to the display frame.
4.
Connect the camera cable to the connector on the camera board.
5.
Replace the display panel (see
Replacing the Display Panel
).
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
1
camera
2
screws (4)
3
camera board brackets (2)
4
camera cable connector