Cooper Instruments & Systems DFI 250X Digital Weight Indicator - Manual (Page 13)

CF 146 11 V- Rev. 1.0 - 003R-620-100
TARG.HI Target for Overweight
Setpoint 1 (Output 1) -99999 to 999999
Default = 000000 Accept
TARG.LO Target for Underweight
Setpoint 2 (Output 2) -99999 to 999999
Default = 000000 Accept
FORMAT Date Format Setting dd.mm.yy or mm.dd.yy Accept
YEAR Year Setting 2000 to 2099
changes position, changes digit. Accept
MONTH Month Setting 01 to 12
changes position, changes digit. Accept
DAY Day Setting 01 to 31
changes position, changes digit. Accept
HOUR Hour Setting 00 to 23
changes position, changes digit. Accept
CLOC
MINUTE Minute Setting 00 to 59
changes position, changes digit. Accept
SCALE Scale Base Test Display Display reads in milliVolts-per-Volt (factory calibrated to 0.1%)
Verify the correct load cell capacity and/or load cell wiring is used. Remove weight
from scale. TEST
FRC.OUT Force Outputs advances through outputs (i.e. ON.1 and ON.2)
turns outputs off and exits test.
Default = OFF
FACTRY DEFLT Restore Factory Defaults
Cont. N (No)
Cont. Y (Yes) Cont. N
Warning: Choosing Cont. Y will clear all stored data except BUILD and CAL
menus. Accept
- END - EXIT SETUP Save settings and return to
normal weighing mode Accept