Bio-Rad Bio-Scale™ Mini CHT™ 40 µm Cartridges - Manual (Page 8)

9
Fig. 3. Column and Fittings.
Inlet fitting
Outlet fitting
3. Hold the cartridge vertically with outlet in the
downward direction. Connect the inlet of the
cartridge to the male luer fitting on the MV-6
sample inject valve (Figure 2). If not using the
MV-6 sample inject valve, connect a barb to
male luer fitting on the 1.6 mm ID tubing, then
connect to the top of the female luer on the
Bio-Scale mini cartridge. For optimum
performance, a cartridge should be mounted
vertically with the arrow on the cartridge pointing
downward.
4. Connect the cartridge outlet to the 1.6 mm ID
tubing leading to the BioLogic LP optics module
or Econo UV monitor. It is recommended to use
the shortest length (approximately 10 cm) of
1.6 mm ID tubing. Connect a barb to female luer
to the 1.6 mm ID tubing, and then connect to
the bottom of the male luer on the Bio-Scale
Mini cartridge.
8
10011433A.qxp 10/30/2007 8:21 AM Page 8