Bio-Rad UView™ 6x Loading Dye plus Mini Transilluminator - Manual (Page 5)

4 UView Mini Transilluminator
Stand-alone Installation
1. Place the instrument on a bench and leave at least 10 cm of
space all around it in order to ensure ample ventilation.
2. Connect the instrument to a power source using the power
cable. The power source must be able to deliver at least 12 V
DC and 1.5 A. The plug must have a ground connection.
3. Install the socket outlet near the equipment and ensure that it
is easily accessible.
General Precautions
The transilluminator is equipped with thermal protection to prevent
overheating.
Clean the transilluminator’s UV filter surface after use. When
using samples stained with ethidium bromide, decontaminate the
transilluminator surface with bleach. Denatured alcohol can be also
used. Always wear disposable gloves.
• Plug the transilluminator into an electric line with a ground
connection
• Do not pour liquids directly on the transilluminator
• Do not block the aeration slits
• Switch off the instrument immediately after use
• Position the transilluminator to prevent harm to nearby
operators