Bio-Rad GelAir Drying System - Manual (Page 4)

Safety
Caution/Warning
The GelAir Dryer is electrically isolated from earth ground to minimize the risk of elec-
trical shock to the user. These guidelines should be observed when using the gel dryer.
• To insure adequate air flow, be sure that there is at least 10 cm of clearance around the gel
dryer. Do not block the fan vent at the rear of the unit.
• Always connect the power supply to a 3-prong, grounded AC outlet, using the 3 prong AC
power cord provided with the dryer.
This instrument should not be modified or altered in any way. Alteration of this instrument
will void the manufacturer’s warranty, and create a potential safety hazard for the user.
Bio-Rad is not responsible for any injury or damage caused by the use of this instrument
for purposes other than for which it is intended or by modifications of the instrument not per-
formed by Bio-Rad or an authorized agent.
Important
This instrument is intended for laboratory use only.
This product conforms to the “Class A” standards for electromagnetic emissions intend-
ed for laboratory equipment applications. It is possible that emissions from this product may
interfere with some sensitive appliances when placed nearby or in the same circuit as those
appliances. The user should be aware of this potential and take appropriate measures to avoid
interference.
This Bio-Rad product 115 V and 230 V is certified to meet CAN/CSA C22.2
No. 1010-1 and UL 3101-1 safety standards. Additionally the 230 V is certified to
EN61010-1* safety standards. These products are safe to use when operated in accor-
dance with the instruction manual.
This instrument should not be modified or altered in any way. Alteration of this instrument
will void the manufacturer’s warranty, void the CE, EN61010-1, CAN/CSA C22.2
No. 1010-1 and UL 3101-1 certification, and create a potential safety hazard for the user.
Bio-Rad is not responsible for any injury or damage caused by the use of this instrument
for purposes other than for which it is intended or by modifications of the instrument not per-
formed by Bio-Rad or an authorized agent.
*EN61010-1 certification is an internationally accepted electrical safety and EMC standard for laboratory instrumentation,
which includes the CE mark.
iii