Bio-Rad Model 583 Gel Drying Supports - Manual (Page 20)

17
Specifications
APPENDIX B. SPECIFICATIONS
Dryer body Polycarbonate
Drying surface 35 x 45 cm
Weight 9.8 kg
Dimensions 11 x 55 x 50 cm
Gel support plate Porous polypropylene, average 120 µm pore size
Sealing gasket Transparent silicone rubber
Heating element 2.5 W/in2 (0.4 W/cm2)
Vacuum source Minimum ultimate vacuum of at least 125 Torr (25” Hg). A pump
with a rating of 28” Hg (48.8 Torr) or better, and a capacity of 20
Iiters/min or better, is recommended.
Electrical connection 3-wire power cord
Power requirements
120 volt models: 100-120 V, 50/60 Hz
240 volt models: 220-240 V, 50/60 Hz
Power consumed during drying 360 Watts
Power consumed when not drying 15 Watts
Fuses required Type T, 250 V (two each)
100/120 V: 6.3 Amp
220/240 V: 3.15 Amp
Operating temperatures 50° to 90°C
Operating time 5 min to 9 hr 55 min.
Operating cycles 3 programmable drying cycles